PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the front exhaust pipe Click here.

  4. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR

    Click here

  5. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

    A001A7T

    1. Remove the nut and disconnect the floor shift gear shifting rod.

  6. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    A001BUP

    1. Disconnect the switch connector.

    2. Remove the nut, spring washer and transmission control shaft lever.

    3. A001D5T

      Using a screwdriver, pry off the lock washer.

    4. A001FRB

      Remove the lock nut and lock washer.

    5. A0019N5

      Remove the bolt and switch.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.