TRANSMISSION WIRE REMOVAL

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  4. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A001DU7

    1. Remove the 9 bolts, oil pan and gasket from the transmission.

      Note

      Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.

    2. Remove the 3 transmission oil cleaner magnets from the oil pan.

    3. A001DH9

      Examine the particles in the pan.


      1. Collect any steel chips with the removed magnets. Carefully look at the foreign objects and particles in the pan and on the magnets to guess the type of wear which might be found in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

    A001CBE

    1. Remove the 4 bolts and oil strainer from the valve body.

    2. A001BFB

      Remove the O-ring from the oil strainer.

  6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

    A001F6S

    1. Remove the bolt, lock plate and ATF temperature sensor.

    2. Remove the O-ring from the ATF temperature sensor.

    3. Disconnect the oil pressure switch connector.

    4. Disconnect the 8 connectors from the solenoid valves.

    5. A001EH1

      Remove the bolt, detent spring cover and detent spring.

    6. A001AVI

      Remove the 17 bolts and valve body.

      Note

      Do not drop the check ball body and spring.

    7. Disconnect the lever pin from the manual valve.

    8. A001B0D

      Remove the check ball body and spring.

  7. REMOVE TRANSMISSION WIRE

    A001BU7

    1. Disconnect the 3 speed sensor connectors.

    2. A001CUB

      Disconnect the wire connector.

      Tech Tips

      Detach the claw, press down the lever, and then disconnect the transmission wire connector.

    3. A001AJX

      Remove the bolt and pull out the transmission wire.

    4. Remove the O-ring from the transmission wire connector.