Click here

ТОПЛИВНАЯ ФОРСУНКА СНЯТИЕ

Click here
Click here
  1. Click here

    DISCHARGE FUEL SYSTEM PRESSURE

    (Click here)

  2. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. Click here

    REMOVE THROTTLE BODY ASSEMBLY

    (Click here)

  5. Click here

    DISCONNECT NO. 1 FUEL HOSE


    1. A003DS3

      Disconnect the No. 1 fuel hose from the fuel pressure pulsation damper assembly (Click here).

  6. Click here

    REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

    Note:

    Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe sub-assembly.


    1. Disconnect the vacuum hose from the fuel pressure regulator assembly.

    2. Slide the clamp and disconnect the No. 2 fuel hose from the fuel pressure regulator assembly.

    3. A003APD

      Disconnect the 4 fuel injector connectors.

    4. Remove the 2 bolts, fuel pressure pulsation damper assembly and O-ring.

    5. Remove the 2 bolts and fuel delivery pipe sub-assembly together with the 4 fuel injector assemblies.

      Note:

      Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe sub-assembly.

    6. Remove the 2 No. 1 delivery pipe spacers from the cylinder head sub-assembly.

    7. Remove the 4 injector vibration insulators.

    8. A003FEVE01

      Using a screwdriver, pry out the 4 injector spacers and 4 O-rings from the cylinder head sub-assembly.

      Table 1. Text in Illustration
      *a Protective Tape
      Tip:

      Tape the screwdriver tip before use.

  7. Click here

    REMOVE FUEL INJECTOR ASSEMBLY


    1. A003EUO

      Pull out the 4 fuel injector assemblies from the fuel delivery pipe sub-assembly.

      Table 2. Text in Illustration
      A003DCD Pull Out

    2. Remove the O-rings from the fuel injector assemblies.