VEHICLE STABILITY CONTROL SYSTEM ABS Warning Light does not Come ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON Click here.

CAUTION / NOTICE / HINT

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

   
   

   1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to DTCs are not output. A DTCs are output. B

   
   

   B

   INSPECT CAN COMMUNICATION SYSTEM Click here

   A

2. PERFORM ACTIVE TEST USING GTS (ABS WARNING LIGHT)

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the ignition switch to ON.

   3. Select the Active Test on the GTS Click here.

      ABS/VSC/TRC

      Tester Display	Test Part	Control Range	Diagnostic Note
      ABS Warning Light	ABS warning light	Warning light ON/OFF	Can be observed on the combination meter assembly Vehicle condition: Vehicle stopped

   4. Select the Data List on the GTS Click here.

      ABS/VSC/TRC

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      ABS Warning Light	ABS warning light/ ON or OFF	ON: Warning light on OFF: Warning light off	-

   5. Check the operating condition of the ABS warning light when operating it using the GTS.

      Result
      Result Proceed to ABS warning light in the Data List does not change using the Active Test. A ABS warning light in the Data List turns ON/OFF using the Active Test. B

   
   

   A

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   B

3. INSPECT COMBINATION METER ASSEMBLY

   
   

   1. Turn the ignition switch off.

   2. Perform an Active Test of the combination meter assembly using the GTS Click here.

   3. Check the combination meter assembly.

      OK
      The ABS warning light turns on or off in accordance with the Active Test operation.

   
   

   OK

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   NG

   INSPECT METER / GAUGE SYSTEM Click here