ECM REMOVAL

PROCEDURE


  1. PERFORM REGISTRATION


    1. Perform learning values save Click here.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER

    Click here

  5. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. REMOVE NO. 1 AIR CLEANER INLET


    1. A004R5O

      Remove the clip and No. 1 air cleaner inlet.

  10. REMOVE NO. 2 AIR CLEANER INLET


    1. A004T0P

      Remove the bolt and No. 2 air cleaner inlet

  11. REMOVE ECM


    1. Disconnect the 2 ECM connectors.


      1. A004OCC

        Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    2. A004NJ4

      Remove the 2 bolts and ECM with bracket.

    3. A004NPU

      Remove the 4 screws and 2 ECM brackets.