GENERATOR(for 130 A Type) REMOVAL

PROCEDURE


  1. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER


    1. A004O7Q

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  5. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  6. REMOVE FRONT LOWER BUMPER ABSORBER

    Click here

  7. REMOVE ENGINE UNDER COVER

    Click here

  8. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  9. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  10. REMOVE FAN AND GENERATOR V BELT

    Click here

  11. REMOVE GENERATOR ASSEMBLY


    1. Remove the terminal cap.

    2. A004SIB

      Disconnect the generator connector and detach the clamp.

    3. Remove the nut and disconnect the generator wire from terminal B.

    4. Remove the bolt and wire harness clamp bracket.

    5. A004S33

      Remove the 3 bolts and generator.