STEREO JACK ADAPTER ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  5. REMOVE NO. 3 BOX PANEL

    Click here

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  7. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  8. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for RHD)

    Click here

  9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

    Click here

  10. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle and CVT)

    Click here

  11. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Manual Transaxle)

    Click here

  12. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transaxle and CVT)

    Click here

  13. REMOVE BOX BOTTOM PANEL

    Click here

  14. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY


    1. A0054XZ

      Detach the 2 claws and remove the stereo jack adapter.