CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
REMOVE NO. 3 BOX PANEL
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 6 clips and remove the box panel.
*1 | Protective Tape | - | - |
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for RHD)
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
Twist the shift lever knob in the direction indicated by the arrow and remove it.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle and CVT)
Twist the shift lever knob in the direction indicated by the arrow and remove it.
REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Manual Transaxle)
Detach the cover.
Using a moulding remover B, detach the 2 claws.
Detach the 6 clips and remove the console panel.
REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transaxle and CVT)
Using a moulding remover B, detach the 2 claws.
Detach the 6 clips.
Remove the console panel and then disconnect the connector.
REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL
Using a moulding remover B, detach the 2 clips.
*1 | w/ Seat Heater System |
Remove the finish panel and then disconnect the connectors.
REMOVE REAR CONSOLE BOX CUP HOLDER
Remove the cup holder.
REMOVE CONSOLE BOX CARPET
Remove the 2 carpets.
REMOVE CONSOLE BOX ASSEMBLY
for Manual Transaxle:
Remove the 2 screws.
for Automatic Transaxle and CVT:
Remove the 4 screws.
Disconnect the connectors.
Remove the 4 bolts and console box.
*1 | for Manual Transaxle: |
*2 | for Automatic Transaxle: |