VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1419, C1435

DTC Code DTC Name
C1419 Acceleration Sensor Internal Circuit
C1435 Yaw Rate Sensor Internal Circuit

DESCRIPTION

These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (yaw rate sensor).

The yaw rate sensor has a built-in acceleration sensor.

DTC No. DTC Detection Condition Trouble Area
C1419 With the +BS terminal voltage between 9.6 and 16.5 V, an acceleration sensor malfunction signal is received from the acceleration sensor. Acceleration sensor (yaw rate sensor)
C1435 With the +BS terminal voltage between 9.6 and 16.5 V, a yaw rate sensor malfunction signal is received from the yaw rate sensor. Yaw rate sensor

CAUTION / NOTICE / HINT

Note

When replacing the yaw rate and acceleration sensor (yaw rate sensor), perform acceleration sensor zero point calibration Click here.

PROCEDURE


  1. REPLACE YAW RATE SENSOR


    1. Replace the yaw rate and acceleration sensor (yaw rate sensor) Click here.

      Tech Tips

      If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step Click here.


    NEXT

    END