TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE

1. REMOVE NO. 2 CYLINDER HEAD COVER

   Click here

2. REMOVE AIR CLEANER CAP AND HOSE

   Click here

3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click here

4. REMOVE NO. 2 ENGINE UNDER COVER

   Click here

5. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR

6. REMOVE FRONT EXHAUST PIPE ASSEMBLY

   Click here

7. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR

   

   
   

   1. Remove the 5 nuts and heat insulator.

8. REMOVE CONSOLE BOX ASSEMBLY

   
   

   1. Remove the console box assembly Click here

9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

   
   

   1. Move the shift lever to N.

   2. 

      Disconnect the end of the transmission control cable from the shift lever.

   3. 

      Text in Illustration

      *1	Stopper
      *2	Nut

      Pull out the stopper of the transmission control cable.

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

   4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

   5. 

      Remove the nut and disconnect the control cable from the control shaft lever.

   6. Remove the clip and disconnect the transmission control cable from the control cable bracket.

   7. 

      Remove the bolt and disconnect the transmission control cable support.

   8. 

      Remove the 2 nuts and disconnect the transmission control cable assembly.

   9. Pull out the transmission control cable assembly to remove it.