INTAKE MANIFOLD REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  4. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  7. REMOVE V-RIBBED BELT

    Click here

  8. REMOVE GENERATOR ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  10. REMOVE THROTTLE BODY ASSEMBLY

    Click here

  11. REMOVE INTAKE MANIFOLD


    1. A0055YY

      Remove the bolt and wire harness clamp bracket.

    2. Detach the 5 clamps and wire harness from the intake manifold.

    3. A0056SW

      Disconnect the fuel vapor feed hose, ventilation hose and vacuum transmitting hose.

    4. A00541O

      Remove the 5 bolts, 2 nuts, intake manifold stay and intake manifold.

    5. A0055WZ

      Remove the gasket from the intake manifold.

    6. A0059IK

      Remove the bolt and wire harness clamp bracket from the intake manifold.

    7. w/ Stud Bolt:


      1. Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.

  12. REMOVE NO. 1 VACUUM TRANSMITTING HOSE


    1. A0056O1

      Remove the vacuum transmitting hose.

  13. REMOVE ENGINE COVER JOINT


    1. Remove the 2 engine cover joints.