PROCEDURE
REMOVE RADIATOR SUPPORT OPENING COVER
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
DRAIN ENGINE COOLANT
REMOVE NO. 2 CYLINDER HEAD COVER
Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.
Note
Attempting to detach both front and rear clips at the same time may cause the cover to break.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the mass air flow meter connector.
Detach the wire harness from the 2 clamps.
Disconnect the 2 clamps.
Disconnect the ventilation hose.
Loosen the band and remove the air cleaner cap.
REMOVE THROTTLE BODY ASSEMBLY
Disconnect the connector and 2 water hoses.
*a | for Type A |
*b | for Type B |
for Type A:
Remove the 2 bolts, 2 nuts and throttle body.
for Type B:
Remove the 4 bolts and throttle body.
Remove the gasket.