REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL ENGINE REAR OIL SEAL


    1. A005673E02

      Apply MP grease to the lip of a new oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A0054Q3E01

      Using SST, hold the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015
      09330-00021

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A0057R3E01
      *1 Transaxle Side
      *2 Front Drive Plate Spacer
      *3 Rear Drive Plate Spacer
      *4 Drive Plate and Ring Gear

      Install the front spacer, drive plate and rear spacer onto the crankshaft.

    3. A0056F5E03

      Clean the bolts and bolt holes.

    4. Apply adhesive to 2 or 3 threads at the end of the 8 bolts.

      Text in Illustration
      *1 Adhesive
      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    5. A0053ZO

      Install the front spacer, drive plate and rear spacer with the 8 bolts. Uniformly tighten the 8 bolts.

      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY


    1. Install the automatic transaxle assembly Click here.

  4. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE


    1. Install the engine assembly with transaxle Click here.