TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  3. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE BATTERY

    Click here

  6. REMOVE BATTERY CARRIER

    Click here

  7. REMOVE AIR CLEANER CAP AND HOSE

    Click here

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  10. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR

  11. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  12. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR

    A0053XU

    1. Remove the 5 nuts and heat insulator.

  13. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  14. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A0057LI

      Disconnect the end of the transmission control cable from the shift lever.

    3. A0055ZFE04
      Text in Illustration
      *1 Stopper
      *2 Nut

      Pull out the stopper of the transmission control cable.

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

    5. A0057I8

      Remove the nut and disconnect the control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable from the control cable bracket.

    7. A0056EI

      Disconnect the control cable from the transmission control cable support.

    8. A005487

      Remove the bolt and disconnect the transmission control cable support.

    9. A0057JC

      Remove the 2 nuts and disconnect the transmission control cable.

    10. Pull out the transmission control cable to remove it.