SPEED SENSOR REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  3. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE BATTERY


    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  6. REMOVE BATTERY CARRIER

    A00560W

    1. Detach the 2 wire harness clamps.

    2. Remove the 4 bolts and battery carrier.

  7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. REMOVE SPEED SENSOR NT

    A0054DD

    1. Disconnect the sensor connector.

    2. Remove the bolt and sensor.

    3. Remove the O-ring from the sensor.

  10. REMOVE SPEED SENSOR NC

    A0057PK

    1. Disconnect the sensor connector.

    2. Remove the bolt and sensor.

    3. Remove the O-ring from the sensor.