DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15C0 | Navigation antenna malfunction |
|
| B15C1 | Navigation antenna power source malfunction |
INSPECTION PROCEDURE
Note
Check that the navigation antenna assembly cable is properly installed and does not have any sharp bends, pinching or loose connections before performing following inspection procedure Click here.
PROCEDURE
CHECK DTC
Clear the DTCs Click here.
Recheck for DTCs and check that no DTCs are output.
| OK |
|---|
| No DTCs are output. |
| NG |
|
INSPECT NAVIGATION ANTENNA ASSEMBLY Click here |
| OK |
|
USE SIMULATION METHOD TO CHECK Click here
INSPECT NAVIGATION ANTENNA ASSEMBLY
| *a | Component without harness connected (Navigation Antenna Assembly) |
Remove the navigation antenna assembly Click here.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPLACE NAVIGATION ANTENNA ASSEMBLY Click here |
| OK |
|
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here