DRIVER MONITOR CAMERA REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the Autoaway/Return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the power switch off.

  2. REMOVE INSTRUMENT SIDE PANEL LH

    A01H24EE01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover D, detach the 6 clips and remove the instrument side panel LH.

  3. REMOVE INSTRUMENT PANEL ORNAMENT

    A01GW3QE01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover B, detach the 4 clips and remove the instrument panel ornament.

    3. Disconnect the connector.

  4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


    1. A01GX9OE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the claw and remove the switch base hole cover from the No. 1 instrument panel safety pad sub-assembly.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01H1X8

      Remove the bolt.

    3. Remove the screw <C>.

    4. Detach the 5 clips and claw and remove the No. 1 instrument panel safety pad sub-assembly.

    5. Disconnect each connector.

  5. REMOVE STEERING COLUMN COVER


    1. for Lower Side:


      1. Remove the 3 screws.

        A01H0SB
      2. A01GWFH

        Detach the 2 claws to remove the steering column cover.

    2. for Upper Side:


      1. A01H02H

        Detach the 4 clips to remove the instrument cluster finish panel sub-assembly.

      2. A01GZ2Y

        Disconnect the driver monitor camera connector.

      3. A01GWGD

        Detach the claw to remove the steering column cover.

  6. REMOVE DRIVER MONITOR BRACKET


    1. A01GYFB

      Detach the claw and disconnect the driver monitor camera connector.

    2. Remove the screw.

    3. Detach the guide and remove the driver monitor bracket.

  7. REMOVE DRIVER MONITOR CAMERA


    1. A01H1GQ

      Remove the 2 screws.

    2. Detach the 2 claws and remove the driver monitor camera.