PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A26

DTC Code DTC Name
C1A26 Lost Communication with Gigabit Video Interface

DESCRIPTION

The driving support ECU uses the front millimeter wave radar sensor, rear millimeter wave radar sensor, driver monitor camera and object recognition camera to detect obstacles in front of and behind the vehicle, and detect the direction that the driver's head is facing. Based on this information, the driving support ECU sends pre-crash control operation signals.

When a video signal format malfunction or communication stop is detected between the object recognition ECU and object recognition camera, this DTC is output.

This DTC is also output from the dynamic radar cruise control system.

DTC Code DTC Detection Condition Trouble Area
C1A26 While power switch is ON (IG), video signal format malfunction or communication stop is detected between object recognition ECU and object recognition camera for 1 second

  • Harness or connector

  • Object recognition camera

  • Object recognition ECU

  • Driving support ECU

WIRING DIAGRAM

A01GW4YE15

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (OBJECT RECOGNITION ECU - OBJECT RECOGNITION CAMERA)


    1. A01GYKXE18

      Disconnect the R58 ECU connector.

    2. Disconnect the X15 camera connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      R58-1 (GVI+) - X15-1 (GVI+) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. REPLACE OBJECT RECOGNITION CAMERA


    1. Replace the object recognition camera Click here.


    NEXT

  3. ADJUST OBJECT RECOGNITION CAMERA


    1. Adjust the object recognition camera Click here.


    NEXT

  4. CHECK FOR DTC


    1. Using the intelligent tester, enter the following menus: Body / Pre-Crash2. Then select "DTC".

    2. Select "Clear" and clear the data.

    3. Recheck for DTC.

      OK
      DTC C1A26 is not output.

    NG

    REPLACE OBJECT RECOGNITION ECU Click here

    OK

    END

  5. REPLACE OBJECT RECOGNITION ECU


    1. Replace the object recognition ECU Click here.


    NEXT

  6. ADJUST OBJECT RECOGNITION CAMERA


    1. Adjust the object recognition camera Click here.


    NEXT

  7. CHECK FOR DTC


    1. Using the intelligent tester, enter the following menus: Body / Pre-Crash2. Then select "DTC".

    2. Select "Clear" and clear the data.

    3. Recheck for DTC.

      OK
      DTC C1A26 is not output.

    NG

    REPLACE DRIVING SUPPORT ECU Click here

    OK

    END