REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
Remove the 2 screws.
Detach the 2 claws as shown in the illustration and remove the No. 1 instrument panel under cover sub-assembly.
Detach the 2 claws and disconnect the DLC3.
Disconnect each connector and detach each wire harness clamp.
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
Detach the 4 claws and remove the No. 2 instrument panel under cover sub-assembly.
Disconnect the connector.
REMOVE FRONT DOOR SCUFF PLATE LH
Put protective tape around the front door scuff plate LH.
*1 | Protective Tape |
Using moulding remover D, detach the 4 clips.
Detach the 7 claws and remove the front door scuff plate LH.
REMOVE COWL SIDE TRIM BOARD LH
Detach the 3 claws and remove the cowl side trim board LH.
REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)
Note
Avoid physical shocks to the accelerator pedal sensor.
Do not disassemble the accelerator pedal sensor assembly.
This accelerator pedal does not require lubrication.
Do not apply oil or lubricant to the accelerator pedal sensor assembly.
If it is applied, the accelerator pedal sensor assembly may not move smoothly.
*A | for LHD |
*B | for RHD |
Disconnect the accelerator pedal sensor connector.
Remove the 3 nuts and accelerator pedal sensor.
REMOVE NO. 3 DASH PANEL INSULATOR PAD (for LHD)
Detach the clamp.
Partially remove the floor carpet.
Remove the No. 1 cooling unit packing and disconnect the No. 2 cooler unit drain hose.
Remove the No. 3 dash panel insulator pad.
REMOVE DASH PANEL EXTENSION LH
for RHD:
Partially remove the floor carpet.
Using a clip remover, detach the wire harness clamp.
Remove the 2 nuts and bolt.
Disconnect the connector and remove the dash panel extension LH and driving support ECU assembly as a unit.
REMOVE DRIVING SUPPORT ECU ASSEMBLY
Remove the nut and driving support ECU assembly.
Note
Do not drop or subject the driving support ECU assembly to strong shocks.
During the removal and installation, do not remove the drip-proof cover.