STEERING ANGLE SENSOR INSTALLATION

Note

While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.


  1. INSTALL STEERING SENSOR


    1. A01GZ13E05
      Text in Illustration
      *1 Pin

      Align the pins on the spiral cable with the installation holes on the steering sensor.

    2. Attach the 6 claws and install the steering sensor to the spiral cable.

  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable sub-assembly with the auxiliary battery connected and the power switch on (IG).

    • Do not rotate the spiral cable sub-assembly with the auxiliary battery connected and the power switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Check that the front wheels are facing straight ahead.

    4. Attach the 3 claws to install the spiral cable subassembly with sensor.

      Note

      When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly.

    5. A01H1UJ

      Connect the yellow airbag connector to the spiral cable sub-assembly with sensor.

    6. Connect the connectors to the spiral cable sub-assembly with sensor.

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

  3. INSTALL STEERING COLUMN COVER

    Click here

  4. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  5. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note


    • Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Click here.

    • When reconnecting the cable to the negative battery terminal after installing the steering sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSPECT STEERING PAD


    1. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system Click here.

  7. INSTALL BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman

      Attach the battery service hole cover LH with the clip and fastening tape.

  8. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Attach the 2 clips to install the deck trim side board LH.

  9. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P
  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI
  11. CHECK SRS WARNING LIGHT

    Click here