CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION


  1. INSTALL AIRBAG SENSOR ASSEMBLY


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note


      • w/ Navigation System (for HDD):

        After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    3. Install the airbag sensor with the 3 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note


      • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the airbag sensor is not loose.

    5. Connect the connector.

  2. INSTALL CONSOLE BOX ASSEMBLY


    1. for Automatic Transmission:


      1. Install the console box assembly Click here.

    2. for Manual Transmission:


      1. Install the console box assembly Click here.

    3. w/ Refrigerated Cool Box:


      1. Install the console box assembly Click here.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.