OCCUPANT CLASSIFICATION SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected:

    System See Procedure
    Parking Assist Monitor System

    Click here

  2. IGNITION SWITCH EXPRESSIONS

    The type of ignition switch used on this model differs according to the specifications of the vehicle.

    The expressions listed in the table below are used in this section.

    Expression Ignition Switch (Position) Engine Switch (Condition)
    Ignition Switch off LOCK Off
    Ignition Switch ACC ACC On (ACC)
    Ignition Switch ON ON On (IG)
    Engine Start START Start

  3. GENERAL PRECAUTION

    Perform zero point calibration and sensitivity check if any of the following conditions occur:


    • The occupant detection ECU is replaced.

    • Accessories (seatback tray and seat cover, etc.) are installed.

    • The front passenger seat is removed from the vehicle.

    • One of the bolts that is used to install the front passenger seat is removed and reinstalled.

    • The vehicle is brought to the workshop for repair due to an accident or a collision.