REPAIR INSTRUCTION INITIALIZATION


  1. PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED

    Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed See page
    Correct the steering angle neutral point Parking assist monitor system

    Click here

    Note


    • After the ignition switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation Receiver Type)

    • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal. (for Radio and Display Type with Intuitive Parking Assist System)

    • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 80*1 or 90*2 seconds before disconnecting the cable from the negative (-) battery terminal. (for Radio and Display Type without Intuitive Parking Assist System)

      *1: w/o Stereo Component Tuner Assembly

      *2: w/ Stereo Component Tuner Assembly

  2. PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

    Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed See page
    ECM Vehicle Identification Number (VIN) registration MIL comes on

    Click here for 2AR-FE

    Click here for 2GR-FE

    ECU communication ID registration (Engine immobiliser system) Engine start

    Click here*1

    Click here*2


    • Throttle with motor body assembly

    • Cleaning the deposits from the throttle with motor body assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft

      (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    Inspection after repair
    • Poor idle, etc.

    • Engine start function, etc.

    Click here for 2AR-FE

    Click here for 2GR-FE

    Automatic transaxle assembly
    1. Reset memory

    2. Input transaxle compensation code into TCM

    3. Perform road test to allow TCM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Click here for U660E Initialization

    Click here for U660E Registration


    • Valve body assembly

    • Shift solenoid valve SL3 and/or SL4


    1. Reset memory

    2. Reset transaxle compensation code

    3. Perform road test to allow TCM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Shift solenoid valve SL1 and/or SL2 Perform road test to allow TCM to learn
    • Large shift shock

    • Deterioration of fuel efficiency

    TCM (If possible, read the transaxle compensation code from the previous TCM) Possible
    1. Reset memory

    2. Transfer transaxle compensation code

    3. Perform road test to allow TCM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Impossible
    1. Reset memory

    2. Reset transaxle compensation code

    3. Perform road test to allow TCM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Automatic transaxle assembly
    1. Reset memory

    2. Input transaxle compensation code into ECM

    3. Perform road test to allow ECM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Click here for U760E Initialization

    Click here for U760E Registration


    • Valve body assembly

    • Shift solenoid valve SL3 and/or SL4


    1. Reset memory

    2. Reset transaxle compensation code

    3. Perform road test to allow ECM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Shift solenoid valve SL1 and/or SL2 Perform road test to allow ECM to learn
    • Large shift shock

    • Deterioration of fuel efficiency

    ECM (If possible, read the transaxle compensation code from the previous ECM) Possible
    1. Reset memory

    2. Transfer transaxle compensation code

    3. Perform road test to allow ECM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Impossible
    1. Reset memory

    2. Reset transaxle compensation code

    3. Perform road test to allow ECM to learn


    • Large shift shock

    • Deterioration of fuel efficiency

    Door control and tire pressure monitoring system receiver assembly Transmitter ID registration (Tire pressure warning system)
    • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

    • Tire pressure warning function

    Click here

    Code registration (Wireless door lock system) Wireless door lock control system

    Click here


    • Tire pressure monitor receiver assembly

    • Tire pressure warning valve and transmitter

    Transmitter ID registration
    • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

    • Tire pressure warning function

    Click here

    Skid control ECU (Brake actuator assembly) Perform system variant learning
    • Slip indicator light illumination

    • VSC disabled or malfunctioning

    Click here

    Power steering ECU assembly
    • Torque sensor zero point calibration*3*4

    • Assist map writing


    • P/S warning light comes on

    • EPS control

    Click here*3

    Click here*4

    Click here*5

    Electric power steering column sub-assembly (containing the torque sensor)*3*4 Torque sensor zero point calibration Steering effort is different between turning steering wheel to left and right

    • Spiral cable with sensor sub-assembly

    • Spiral cable sub-assembly

    • Steering sensor


    • Steering angle neutral point (Initialize parking assist monitor system)

    • Steering angle setting

    Parking assist monitor system

    Click here

    Navigation ECU sub-assembly Navigation ECU sub-assembly initialization Parking assist monitor system
    Rear television camera assembly Back camera position setting Parking assist monitor system
    Blind spot monitor sensor Blind spot monitor beam axis inspection DTCs are output

    Click here


    • Roof console box assembly*6

    • Garage door opener transmitter*6

    Re-registration of codes in the garage door opener system


    • Register transmitter code

    • Rolling code systems

    Garage door opener system

    Click here

    DCM (Telematics Transceiver) DCM activation Safety connect system

    Click here


    • Certification ECU (smart key ECU assembly)*1

    • Steering lock ECU (steering lock actuator assembly)*1

    • Electrical key transmitter sub-assembly*1

    Code registration (Engine immobiliser system)
    • Wireless door lock control system

    • Smart key system

    • Engine start

    • Steering lock system

    Click here


    • Transponder key ECU assembly*2

    • Door control transmitter assembly*2

    • Key*2

    Code registration (Engine immobiliser system) Engine start

    Click here


    • Door control transmitter assembly*2

    • Door control receiver

    Code registration (Wireless door lock system) Wireless door lock control system

    Click here


    • Remote engine starter ECU*7

    • Certification ECU (smart key ECU assembly)*7

    Registration of remote engine starter ID (Remote engine starter system) Remote engine start

    Click here


    • Occupant classification ECU

    • Front passenger seat

    Zero point calibration and sensitivity check. (Occupant classification system)
    • Occupant classification system

    • Passenger airbag ON/OFF indicator

    • Airbag system (Front passenger side)

    • Seat belt warning system (Front passenger)

    Click here


    • No. 1 air conditioning radiator damper servo sub-assembly*8*9

    • No. 2 air conditioning radiator damper servo sub-assembly*8

    • No. 1 blower damper servo sub-assembly*8*9

    Initialization servo motor (Air conditioning system) DTCs are output

    Click here*8

    Click here*9


    • Power window regulator motor assembly

    • Door window regulator sub-assembly

    • Door glass

    • Door glass run

    Initialize power window control system
    • Auto up/down function

    • Jam protection function

    • Operation function after ignition switch is turned off

    • Key-linked function

    • Wireless transmitter-linked function

    Click here


    • Sliding roof ECU (sliding roof drive gear sub-assembly)

    • Sliding roof glass sub-assembly

    • Sliding roof drive cable sub-assembly

    Initialize sliding roof ECU (pulse sensor initial position setting)
    • Automatic slide open/close and tilt up/down function of sliding roof

    • Jam protection function

    • Operation function after ignition switch is turned off

    • Key-linked function

    • Wireless transmitter-linked function

    • Sliding roof open warning

    Click here

    Headlight leveling ECU assembly Perform headlight leveling ECU assembly initialization Headlight leveling function

    Click here

    Rear height control sensor sub-assembly Perform headlight leveling ECU assembly initialization Headlight leveling function

    • *1: w/ Smart Key System

      *2: w/o Smart Key System

      *3: for 2AR without Wireless Door Lock

      *4: for 2AR with Wireless Door Lock

      *5: for 2GR

      *6: w/ Garage Door Opener System

      *7: w/ Remote Engine Starter System

      *8: for Automatic Air Conditioning System

      *9: for Manual Air Conditioning System