INTEGRATION RELAY REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 RELAY BLOCK COVER


    1. A01HMTM

      Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.

  4. REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY


    1. Disengage the 2 claws as shown in the illustration.

      A01HORTE01
      Text in Illustration
      *1 Protective Tape *a Pulled Position

    2. Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room relay block assembly.

      Note

      When pulling a engine room junction block assembly, take care not to damage the engine room junction block assembly.

      Tech Tips

      Tape the pliers tips before use.

    3. A01HPAF

      Disconnect the 2 connectors and remove the engine room junction block assembly.

      Note


      • Do not drop or allow any impact on parts.

      • Do not touch the connector.