HARD DISK DRIVE REMOVAL


  1. PRECAUTION

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

    • A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store multi-media data, and is used for the audio and visual system. Therefore, care must be taken for the following points when handling the navigation receiver assembly.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  4. REMOVE BOX BOTTOM MAT


    1. A01HMY5

      Remove the box bottom mat.

  5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01HOHW

      Remove the 2 screws <C> or <D>.

    2. A01HNXD

      Disengage the 4 clips and guide as shown in the illustration.

    3. Disconnect each connector to remove the upper console panel sub-assembly.

  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A01HN72

      Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.

    2. A01HQ31

      Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.

    3. A01HPK9

      Disengage the 3 claws and 2 clips as shown in the illustration.

    4. A01HQ1I

      Disengage the clamp.

    5. Disconnect the connector to remove the center instrument cluster finish panel assembly.

  7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HQDQ

      Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 6 clips to remove the No. 2 instrument panel register assembly.

  8. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    1. A01HNZO

      Apply protective tape to the area shown in the illustration.

      Text in Illustration
      A01HPW1 Protective Tape
    2. A01HP6V

      Remove the 4 bolts.

    3. A01HORE

      Pull the radio receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.

    4. Disconnect each connector and remove the radio receiver assembly with air conditioning control assembly.

  9. REMOVE NO. 2 RADIO BRACKET


    1. w/o Satellite Radio:


      1. A01HNZB

        Remove the 5 screws and No. 2 radio bracket.

    2. w/ Satellite Radio:


      1. A01HOXY

        Remove the 7 screws and No. 2 radio bracket.

  10. REMOVE HARD DISK DRIVE


    1. A01HMMG

      Remove the 2 screws.

    2. Disengage the 2 guides to remove the cover.

    3. A01HQJ7

      Pull out the hard disk drive from the navigation receiver assembly in the direction shown by the arrow in the illustration to remove it.