Click here

СИСТЕМА SFI, Diagnostic DTC:P144C, P144D

Click here
Click here
DTC Code DTC Name
P144C Open in Secondary Air Injection System Heater Control Circuit
P144D Short in Secondary Air Injection System Heater Control Circuit
Click here

DESCRIPTION

The ECM operates the air pump heater relay (AI PMP HTR) which causes the air pump heater to operate.

DTC No. DTC Detection Condition Trouble Area
P144C Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic).

  • Open or short in air pump heater relay circuit

  • air pump heater relay (AI PMP HTR)

  • ECM
P144D Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic).

  • Open or short in air pump heater relay circuit

  • air pump heater relay (AI PMP HTR)

  • ECM
Click here

WIRING DIAGRAM

Refer to DTC P0412 (Click here).

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses of circuits related to this system before performing the following inspection procedure.

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

Click here

PROCEDURE


  1. Click here

    INSPECT AIR PUMP HEATER RELAY (AI PMP HTR)


    1. Inspect the air pump heater relay (AI PMP HTR) (Click here).


  2. Click here

    CHECK AIR PUMP HEATER RELAY (AI PMP HTR) (POWER SOURCE)


    1. Remove the air pump heater relay (AI PMP HTR).

    2. A01ER6UE01

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      air pump heater relay (AI PMP HTR) terminal 2 - Body ground Engine switch on (IG) 11 to 14 V
      Table 1. Text in Illustration
      *1 Engine Room Relay Block
      *2 air pump heater relay (AI PMP HTR)

    3. Reinstall the air pump heater relay (AI PMP HTR).


  3. Click here

    CHECK HARNESS AND CONNECTOR (ECM - AIR PUMP HEATER RELAY [AI PMP HTR])


    1. Remove the air pump heater relay (AI PMP HTR).

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      air pump heater relay (AI PMP HTR) terminal 1 - C54-60 (HAI1) Always Below 1 Ω
      air pump heater relay (AI PMP HTR) terminal 1 or C54-60 (HAI1) - Body ground Always 10 kΩ or higher

    4. Reinstall the air pump heater relay (AI PMP HTR).

    5. Reconnect the ECM connector.


  4. Click here

    REPLACE AIR PUMP HEATER RELAY (AI PMP HTR)

  5. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  6. Click here

    REPLACE ECMClick here

  7. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - AIR PUMP HEATER RELAY [AI PMP HTR])