Click here

СИСТЕМА SFI, Diagnostic DTC:P0560

Click here
Click here
DTC Code DTC Name
P0560 System Voltage
Click here

DESCRIPTION

The battery supplies electricity to the ECM even when the engine switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the memory is cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM illuminates the MIL and stores the DTC.

DTC No. DTC Detection Condition Trouble Area
P0560 Open in the ECM backup power source circuit (1 trip detection logic).

  • Open in backup power source circuit

  • Battery

  • Battery terminals

  • EFI MAIN fuse

  • ECM
Tip:

If DTC P0560 is stored, the ECM does not store other DTCs and the data stored in the ECM is partly cleared.

Click here

CONFIRMATION DRIVING PATTERN


  1. Turn the engine switch on (IG) and wait for 5 seconds or more.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (ECM - BATTERY)


    1. Disconnect the ECM connector.

    2. Disconnect the cable from the positive (+) battery terminal.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A53-1 (BATT) - Battery positive (+) terminal Always Below 1 Ω
      A53-1 (BATT) or Battery positive (+) terminal - Body ground Always 10 kΩ or higher

  2. Click here

    INSPECT BATTERY


    1. Check that the battery is not depleted (Click here).

      OK
      Battery is not depleted.

  3. Click here

    CHECK BATTERY TERMINAL


    1. Check that the battery terminals are not loose or corroded.

      OK
      Battery terminals are not loose or corroded.

  4. Click here

    CHECK WHETHER DTC OUTPUT RECURS


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Clear DTCs (Click here).

    5. Turn the engine switch off.

    6. Turn the engine switch on (IG) and turn the GTS on.

    7. Wait 5 seconds or more.

    8. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    9. Read DTCs.

      Table 1. Result
      Result Proceed to
      P0560 is output A
      No DTC is output B

  5. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  6. Click here

    REPLACE BATTERY

  7. Click here

    REPAIR BATTERY TERMINAL

  8. Click here

    CHECK FOR INTERMITTENT PROBLEMSClick here

  9. Click here

    REPLACE ECMClick here