DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE ENGINE ROOM SIDE COVER LH
Remove the 7 clips and engine room side cover LH.
DISCONNECT CONNECTOR HOLDER BLOCK
Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.
REMOVE ECM
*1 | Lock |
*a | Push |
Raise the 2 levers while pushing the locks on the 2 levers.
Note
Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.
Disconnect the 2 connectors.
Remove the 4 bolts and ECM.
REMOVE GASKET
Peel off the gasket.
*1 | Cloth |
Spray gasket remover or equivalent on the remaining tape of the gasket.
Note
When using gasket remover or equivalent, cover the ECM connectors with a cloth.
Remove the tape of the gasket without using bladed objects.