SIDE AIRBAG SENSOR INSTALLATION


  1. INSTALL SIDE AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A016337E01

      Install the side airbag sensor with the nut and pin.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

      • Make sure that the pin is securely inserted into the body hole.

      • Tighten the nut while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.

    4. Connect the connector to the side airbag sensor.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.

    5. Check that there is no looseness in the installation parts of the side airbag sensor.

  2. INSTALL FRONT SEAT BELT RETRACTOR COVER


    1. A015YU1

      Install the front seat belt retractor cover to the body with the claw.

  3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. A01603LE01

      Check the degree of tilt when the ELR begins to lock.


      1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.

        Note

        Do not disassemble the retractor.

    2. A0162AJE03

      Temporarily install the front seat outer belt assembly with the 2 bolts.

    3. Fully tighten the bolt (A) first, then the bolt (B) to install the front seat outer belt assembly.

      Torque:
      Bolt A
      7.5 N*m  { 77 kgf*cm, 66 in.*lbf }
      Torque:
      Bolt B
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    4. A01628O

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    5. Connect the connectors.

  4. INSTALL LOWER CENTER PILLAR GARNISH


    1. A01604OE01

      Engage the 5 clips and 3 claws, and install the lower center pillar garnish LH.

  5. INSTALL REAR DOOR SCUFF PLATE


    1. A016266

      Engage the 2 clips.

    2. A015YIJ

      Engage the 5 claws and install the rear door scuff plate LH.

  6. INSTALL FRONT DOOR SCUFF PLATE


    1. A015ZPR

      Engage the 4 clips.

    2. A0161H2

      Engage the 7 claws and install the front door scuff plate LH.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.