KNEE AIRBAG ASSEMBLY (for Driver Side) INSTALLATION


  1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the battery negative (-) cable is disconnected.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Connect the driver side knee airbag connector to the driver side knee airbag assembly.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.

    4. A0161L3

      Temporarily install the driver side knee airbag assembly with the 2 pins.

    5. A0160VX

      Install the driver side knee airbag assembly with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    6. A0160SH

      Install the hood lock control cable with the claw.

  2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. A0160VQ

      Connect the connectors.

    2. Engage the 7 clips and install the lower instrument panel finish panel sub-assembly.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A015ZC2E01

      Connect the connectors.

    2. Insert the No. 1 instrument panel under cover sub-assembly into the guide as shown in the illustration.

    3. Engage the 2 claws.

    4. Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <D>.

  4. INSTALL SIDE INSTRUMENT PANEL LH


    1. A015ZMU

      Engage the 5 claws and 3 clips, and then install the side instrument panel LH.

  5. INSTALL FRONT DOOR OPENING TRIM COVER LH


    1. A016285

      Engage the 4 claws and install the front door opening trim cover LH.

  6. INSTALL FRONT DOOR SCUFF PLATE LH


    1. A015ZPR

      Engage the 4 clips.

    2. A0161H2

      Engage the 7 claws and install the front door scuff plate LH.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.