GLOVE BOX LIGHT INSTALLATION


  1. INSTALL GLOVE BOX LIGHT ASSEMBLY


    1. A0162OL

      Engage the 2 claws and install the glove box light assembly.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. A01605K

      Connect the connectors.

    2. Engage the 2 claws.

    3. Install the glove compartment door assembly with the 5 screws <D>.

  3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the battery negative (-) cable is disconnected.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A0160QYE01

      Connect the front passenger side knee airbag connector to the front passenger side knee airbag assembly.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.

    4. Install the front passenger side knee airbag assembly with the 3 bolts and claw.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A015YZF

      Engage the 4 clips to install the No. 2 instrument panel under cover sub-assembly.

  5. INSTALL SIDE INSTRUMENT PANEL RH


    1. A015ZMM

      Engage the 5 claws and 3 clips to install the side instrument panel RH.

  6. INSTALL FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  7. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure for the RH side and the LH side Click here.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    Some systems need to be initialized after the cable is reconnected Click here.

  9. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.