YAW RATE AND ACCELERATION SENSOR INSTALLATION


  1. INSTALL YAW RATE AND ACCELERATION SENSOR


    1. A015ZLDE01

      Connect the yaw rate and acceleration sensor connector.

    2. A0162JJ

      Install the yaw rate and acceleration sensor with the 2 bolts.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note


      • Do not damage the yaw rate and acceleration sensor.

      • Make sure that the yaw rate and acceleration sensor is installed securely.

    3. Install the 2 wire harness clamps.

  2. INSTALL NO. 2 CONSOLE BOX DUCT


    1. A0162NO

      Install the No. 2 console box duct with the 2 clips.

  3. INSTALL CONSOLE BOX


    1. A0162J5

      Engage the 2 claws and 2 clips.

    2. A015ZEK

      Install the 2 bolts.

    3. A0162NA

      Install the 2 bolts.

    4. Connect the connector.

    5. A0160S1

      Connect the 2 connectors.

    6. Engage the 2 clamps.

    7. Install the 2 bolts.

  4. INSTALL CONSOLE BOX REGISTER ASSEMBLY


    1. A01638Q

      Engage the 2 claws and 4 clips, and then install the console box register assembly.

  5. INSTALL REAR ASH RECEPTACLE ASSEMBLY


    1. Install the rear ash receptacle assembly.

  6. INSTALL FRONT ASH RECEPTACLE ASSEMBLY


    1. A0161X0E01

      Connect the connectors.

    2. Insert the protruding parts of the front ash receptacle assembly into the 2 guide holes as shown in the illustration.

    3. A0161L2

      Install the front ash receptacle assembly with the 2 screws <E>.

  7. INSTALL CONSOLE PANEL SUB-ASSEMBLY


    1. A0162AI

      Connect the connectors.

    2. Engage the 8 clips to install the console panel sub-assembly.

  8. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH


    1. A0163A0

      Engage the claw and 2 clips to install the upper No. 2 console panel garnish.

  9. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH


    1. A01626T

      Engage the claw and 2 clips to install the upper No. 1 console panel garnish.

  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A015ZOR

      Turn the shift lever knob clockwise and install the shift lever knob sub-assembly.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

    Tech Tips

    Click here.

  13. CHECK FOR SENSOR SIGNAL

    Tech Tips

    Click here.