STEERING PAD SWITCH INSTALLATION


  1. INSTALL STEERING PAD SWITCH ASSEMBLY


    1. A0161GT

      Engage the 2 claws and install the steering pad switch.

    2. Install the screw.

    3. A0160WI

      Engage the 2 claws and install the steering pad switch.

    4. Install the screw.

    5. Connect the connector to the spiral cable.

    6. A0161WI

      Connect the cruise connector and install the connector clamp.

  2. INSTALL STEERING PAD


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A0161J5

      Connect the 2 airbag connectors to the steering pad.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.

    4. Connect the horn connector to the steering pad.

    5. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

    6. A01600XE01

      Using a "TORX" socket wrench (T30), tighten the 2 "TORX" screws.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }
  3. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. A015ZUQ

      Install the lower No. 3 steering wheel cover with the claw.

  4. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A0160QU

      Install the lower No. 2 steering wheel cover with the claw.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSPECT SRS WARNING LIGHT

    Click here