AMPLIFIER ANTENNA INSTALLATION


  1. INSTALL AMPLIFIER ANTENNA ASSEMBLY


    1. A0162HH

      Engage the clip as shown in the illustration to temporarily install the amplifier antenna assembly.

      Note


      • Clean the antenna conductors on the rear window with a non-residue solvent where the contact terminals will touch.

      • When installing a new amplifier antenna assembly, do not remove the protective cover until immediately before installation.

      • Do not touch the contact terminals.

    2. A0162PE

      Install the 2 nuts and amplifier antenna assembly.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

    3. Connect the connector.

    4. Engage the clamp.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

    Tech Tips

    Refer to the procedures from "Install Roof Headlining Assembly".

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSPECT SRS WARNING LIGHT

    Click here