Click here

ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System), Diagnostic DTC:B2799

Click here
Click here
DTC Code DTC Name
B2799 Engine Immobiliser System Malfunction
Click here

DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.

DTC No. DTC Detection Condition Trouble Area
B2799

One of following conditions is met:


  • Error in communication between ECM and transponder key ECU

  • Error in communication lines

  • Communication ID is different during communication with transponder key ECU

  • Wire harness or connector

  • ECM

  • Transponder key ECU assembly
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

  • If the transponder key ECU is replaced, register the key and ECU communication ID.

  • If the ECM is replaced, register the ECU communication ID.

Click here

PROCEDURE


  1. Click here

    CHECK DTC OUTPUT


    1. Delete the DTCs (Click here).

    2. Recheck for DTCs.

      OK
      B2799 output does not recur.

  2. Click here

    RE-REGISTER ECU COMMUNICATION ID


    1. Re-register the ECU communication ID.


  3. Click here

    CHECK DTC OUTPUT


    1. Delete the DTCs (Click here).

    2. Recheck for DTCs.

      OK
      B2799 output does not recur.

  4. Click here

    CHECK CONNECTION OF CONNECTOR


    1. Turn the ignition switch off.

    2. Check that the connectors are properly connected to the ECM and the transponder key ECU.

      OK
      Connectors are properly connected.

  5. Click here

    CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)


    1. A017DDIE02

      Disconnect the transponder key ECU and ECM connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      D37-12 (EFII) - D32-15 (IMO) Always Below 1 Ω
      D37-13 (EFIO) - D32-16 (IMI) Always Below 1 Ω
      D37-12 (EFII) - Body ground Always 10 kΩ or higher
      D37-13 (EFIO) - Body ground Always 10 kΩ or higher

  6. Click here

    REPLACE ECM


    1. Replace the ECM (Click here).


  7. Click here

    REGISTER ECU COMMUNICATION ID


    1. Register the ECU communication ID.


  8. Click here

    CHECK DTC OUTPUT


    1. Delete the DTCs (Click here).

    2. Recheck for DTCs.

      OK
      B2799 output does not recur.

  9. Click here

    USE SIMULATION METHOD TO CHECKClick here

  10. Click here

    END (PROBLEM WITH ECU COMMUNICATION ID IS DEFECTIVE)

  11. Click here

    CONNECT CONNECTORS PROPERLY

  12. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  13. Click here

    REPLACE TRANSPONDER KEY ECU ASSEMBLY

  14. Click here

    END (ECM IS DEFECTIVE)