REAR SUNSHADE ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL REAR SUNSHADE ASSEMBLY

    A01GJM2

    1. Temporarily install the rear sunshade assembly with the bolt labeled A.

      Text in Illustration
      A01GKOV Bolt A

    2. Install the 4 bolts and tighten the bolt labeled A.

  2. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. Attach the 5 claws and 3 clips to install the No. 2 package tray trim panel assembly.

  3. INSTALL STEREO COMPONENT SPEAKER ASSEMBLY

    Note

    Do not touch the cone part of the speaker.


    1. Install the stereo component speaker assembly with the 4 bolts.

      A01GJVIE02
      Text in Illustration
      *A for Standard *B for 19 Speakers

      Tech Tips

      Install the bolts in the order shown in the illustration.

    2. Connect the connector.

  4. INSTALL REAR NO. 4 AIR DUCT (w/ Rear Cooler)


    1. Attach the 4 claws to install the rear No. 4 air duct.

  5. INSTALL REAR NO. 5 AIR DUCT (w/ Rear Cooler)


    1. Attach the 4 claws to install the rear No. 5 air duct.

  6. INSTALL NO. 2 ROOF SIDE AIR DUCT LH (w/ Rear Cooler)


    1. Attach the 2 claws to install the roof side No. 2 air duct LH.

    2. Install the clip.

  7. INSTALL NO. 2 ROOF SIDE AIR DUCT RH (w/ Rear Cooler)


    1. Attach the 2 claws to install the roof side No. 2 air duct RH.

    2. Install the clip.

  8. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. w/ Rear Cooler:

      Connect the solar sensor connector.

    2. except 4-Passenger with Ottoman:

      Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    3. for 4-Passenger with Ottoman:

      Pass the 2 rear seat belt floor anchors through the package tray trim panel assembly.

    4. Insert the rear part of the package tray trim panel assembly into the rear sunshade assembly.

    5. Attach the 2 clips to install the package tray trim panel assembly.

    6. except 4-Passenger with Ottoman:

      Attach the 4 claws to install the 3 belt guides.

    7. for 4-Passenger with Ottoman:

      Attach the 4 claws to install the 2 belt guides.

  9. INSTALL INNER ROOF SIDE GARNISH LH

    A01GK2ME06
    Text in Illustration
    *1 Clip A

    1. Install a new clip A to the inner roof side garnish LH.

    2. Attach the 2 claws and 5 clips to install the inner roof side garnish LH.

  10. INSTALL INNER ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  11. INSTALL REAR SEAT SIDE GARNISH LH


    1. Attach the 6 claws to install the rear seat side garnish LH.

  12. INSTALL REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  13. INSTALL REAR DOOR SCUFF PLATE LH


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  14. INSTALL REAR DOOR SCUFF PLATE RH


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  15. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)

    Click here

  16. INSTALL REAR SEAT ASSEMBLY (for Power Seat)

    Click here

  17. INSTALL REAR SEAT ASSEMBLY (for 4-Passenger with Ottoman)

    Click here

  18. INSTALL REAR SEAT ASSEMBLY (for 5-Passenger with Ottoman)

    Click here

  19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  20. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.

  21. CHECK SRS WARNING LIGHT

    Click here