REAR POWER SEAT MOTOR ASSEMBLY (for Power Seat) REMOVAL

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Before removing the rear seat, make sure to move the seat 37 mm (1.46 in.) from the rearmost position.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      for LHD:

      Remove the 6 clips and cowl top ventilator louver RH.

    2. A01GI9P

      for RHD:

      Remove the 6 clips and cowl top ventilator louver LH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR SEAT CUSHION ASSEMBLY LH

    A01GLQWE01

    1. Detach the 2 front hooks of the rear seat cushion assembly LH from the rear No. 2 seat adjuster assembly.

      Note


      • If the areas close to the insertion location of the rear seat cushion lock hooks (A) are not lifted straight up, the cushion spring may become deformed.

      • When lifting the rear seat cushion assembly LH, lift it quickly so that force is applied directly to the hooks. Do not lift it slowly.

      Specification
      Area Measurement
      a 114 mm (4.49 in.)
      b 100 mm (3.94 in.)

    2. Detach the rear hook of the rear seat cushion assembly LH to remove the rear seat cushion assembly LH from the rear seatback spring assembly LH.

      Note

      Be careful not to damage the vehicle body.

    3. Disconnect the connector.

  5. REMOVE REAR SEAT CUSHION ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE REAR SEATBACK ASSEMBLY LH


    1. A01GMB3

      Remove the bolt and disconnect the anchor part of the rear seat 3 point type belt assembly LH.

    2. A01GI1OE03
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 2 claws and open the 2 caps of the rear seat shoulder belt guide.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect the seat belt from the shoulder belt guide.

    4. A01GN8I

      Remove the bolt and pull out the junction block.

    5. Disconnect the 2 connectors.

    6. A01GL9B

      Detach the 7 wire harness clamps and disconnect the 3 connectors.

    7. A01GK8WE04
      Text in Illustration
      *1 Fastening Tape

      Detach the 3 pieces of fastening tape and using a clip remover, detach the clip.

    8. Remove the 2 nuts and disconnect the air duct from the vehicle body.

    9. Disconnect the rear seatback assembly LH from the rear No. 2 seat adjuster assembly and lift the rear seatback assembly LH upwards to remove it.

      Note

      Be careful not to damage the vehicle body.

  7. REMOVE REAR SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.

  8. REMOVE REAR NO. 2 SEAT ADJUSTER ASSEMBLY


    1. A01GKGY

      Remove the nut and disconnect the anchor part of the rear center seat outer belt assembly.

    2. A01GJM1

      Remove the 4 bolts, nut and rear No. 2 seat adjuster assembly.

      Note

      Be careful not to damage the vehicle body.

    3. Disconnect the air duct from the vehicle body.

  9. REMOVE REAR SEAT BELT INNER ANCHOR BRACKET ASSEMBLY LH

    A01GIO3

    1. Remove the nut and rear seat belt inner anchor bracket assembly LH.

  10. REMOVE SEAT CLIMATE CONTROL CONTROLLER LH


    1. A01GKFA

      Remove the rear No. 2 seat cushion pad.

    2. A01GHN7

      Detach the 2 wire harness clamps and disconnect the 2 connectors.

    3. A01GMDK

      Remove the 2 screws.

    4. Detach the 2 claws to remove the seat climate control controller LH.

  11. REMOVE REAR SEAT CLIMATE CONTROL BLOWER LH


    1. A01GJLG

      Disconnect the connector.

    2. A01GMYO

      Remove the 3 nuts and rear seat climate control blower LH.

  12. REMOVE REAR NO. 1 SEAT ADJUSTER ASSEMBLY


    1. A01GIDI

      Remove the 4 bolts, nut and rear No. 1 seat adjuster assembly.

      Note

      Be careful not to damage the vehicle body.

    2. Disconnect the air duct from the vehicle body.

  13. REMOVE REAR SEAT BELT INNER ANCHOR BRACKET ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.

  14. REMOVE SEAT CLIMATE CONTROL CONTROLLER RH

    Tech Tips

    Use the same procedures described for the LH side.

  15. REMOVE REAR SEAT CLIMATE CONTROL BLOWER RH

    Tech Tips

    Use the same procedures described for the LH side.

  16. REMOVE REAR SEAT HEADREST ASSEMBLY


    1. A01GLT3

      Remove the 2 pins and rear seat headrest assembly.

      Tech Tips

      Use the same procedure to remove the rear seat headrest assembly on the other side.

  17. REMOVE REAR SEAT HEADREST SUPPORT


    1. A01GKYP

      Detach the 4 claws and remove the 2 rear seat headrest supports.

      Tech Tips

      Use the same procedure to remove the rear seat headrest support on the other side.

  18. REMOVE REAR NO. 1 SEAT HEADREST ADJUSTER SUB-ASSEMBLY


    1. A01GN9M

      Detach the wire harness clamp and disconnect the 2 connectors.

    2. Remove the 2 bolts.

    3. Detach the 2 claws to remove the rear No. 1 seat headrest adjuster sub-assembly.

      Tech Tips

      Use the same procedure to remove the rear No. 1 seat headrest adjuster sub-assembly on the other side.

  19. REMOVE REAR SEAT SHOULDER BELT GUIDE LH


    1. A01GNCA

      Remove the 3 screws and rear seat shoulder belt guide LH.

  20. REMOVE POSITION CONTROL ECU ASSEMBLY


    1. A01GKJI

      Disconnect the 2 connectors.

    2. Remove the 2 nuts and position control ECU assembly.

      Tech Tips

      Use the same procedure to remove the position control ECU assembly on the other side.

  21. REMOVE REAR SEAT CLIMATE CONTROL ECU LH


    1. A01GIJ7

      Disconnect the 2 connectors.

    2. Remove the 2 nuts and rear seat climate control ECU LH.

  22. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY


    1. Disconnect the connector.

    2. Detach the guide to remove the seat heater control sub-assembly.

      Tech Tips

      Use the same procedure to remove the seat heater control sub-assembly on the other side.

  23. REMOVE REAR SEAT COVER CAP LH


    1. A01GIOB

      Detach the 5 claws to remove the rear seat cover cap LH.

  24. REMOVE REAR SEAT LOCK BASE LH


    1. A01GICD

      Remove the 3 screws and rear seat lock base LH.

  25. REMOVE REAR SEATBACK COVER WITH PAD LH


    1. Remove the nut and detach the seatback cover bracket.

    2. Disconnect the connector.

    3. Detach the 8 hooks and remove the 19 hog rings and rear seatback cover with pad LH from the rear seatback spring assembly LH.

      A01GLVCE01
      Text in Illustration
      *1 Seatback Cover Bracket *2 Hook

  26. REMOVE REAR SEATBACK CLIMATE CONTROL BLOWER LH

    A01GHX6E02
    Text in Illustration
    *1 Felt Pad

    1. Remove the felt pad.

    2. Disconnect the 3 connectors and detach the wire harness clamp.

    3. Remove the 3 nuts.

    4. Remove the 2 screws and rear seatback climate control blower LH.

  27. REMOVE REAR SEAT WIRE LH


    1. A01GJLD

      Disconnect the 3 connectors.

    2. Detach the 11 wire harness clamps to remove the rear seat wire LH.

  28. REMOVE REAR SEAT SHOULDER BELT GUIDE RH

    Tech Tips

    Use the same procedures described for the LH side.

  29. REMOVE REAR SEAT CLIMATE CONTROL ECU RH

    Tech Tips

    Use the same procedures described for the LH side.

  30. REMOVE REAR SEAT COVER CAP RH

    Tech Tips

    Use the same procedures described for the LH side.

  31. REMOVE REAR SEAT LOCK BASE RH

    Tech Tips

    Use the same procedures described for the LH side.

  32. REMOVE REAR SEATBACK COVER WITH PAD RH

    Tech Tips

    Use the same procedures described for the LH side.

  33. REMOVE REAR SEATBACK CLIMATE CONTROL BLOWER RH

    Tech Tips

    Use the same procedures described for the LH side.

  34. REMOVE REAR SEAT WIRE RH

    Tech Tips

    Use the same procedures described for the LH side.