NAVIGATION ANTENNA REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    CAUTION:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    A01GM4S

    1. Remove the 6 clips and cowl top ventilator louver RH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

    A01GM2F

    1. Remove the screw.

    2. Detach the claw and remove the No. 2 side defroster nozzle duct.

  6. REMOVE DEFROSTER NOZZLE ASSEMBLY

    A01GKTA

    1. Remove the 3 screws and defroster nozzle assembly.

  7. REMOVE NO. 3 HEATER TO REGISTER DUCT

    A01GNK8

    1. Remove the 3 screws and No. 3 heater to register duct.

  8. REMOVE NAVIGATION ANTENNA ASSEMBLY

    A01GLJL

    1. Detach the 4 clamps.

    2. Remove the 2 screws and navigation antenna assembly.