NETWORK GATEWAY ECU (for RHD) REMOVAL


  1. PRECAUTION

    CAUTION:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    A01GM4S

    1. Remove the 6 clips and cowl top ventilator louver RH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT SIDE PANEL RH

    A01GLH5E01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover D, detach the 6 clips and remove the instrument side panel RH.

  5. REMOVE INSTRUMENT PANEL ORNAMENT

    A01GN0QE01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover B, detach the 4 clips and remove the instrument panel ornament.

    3. Disconnect the connector.

  6. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    A01GMOEE01

    1. Using a screwdriver, detach the claw and remove the switch base hole cover from the No. 1 instrument panel safety pad sub-assembly.

      Tech Tips

      Tape the screwdriver tip before use.

      Text in Illustration
      *1 Protective Tape
    2. A01GNWZ

      Remove the bolt.

    3. Remove the screw <C>.

    4. Detach the 5 clips and claw and remove the No. 1 instrument panel safety pad sub-assembly.

    5. Disconnect each connector.

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01GNJE

    1. Remove the 2 screws.

    2. Detach the 2 claws as shown in the illustration and remove the No. 1 instrument panel under cover sub-assembly.

    3. Detach the 2 claws and disconnect the DLC3.

    4. Disconnect each connector and each wire harness clamp.

  8. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    CAUTION:

    When storing the driver side knee airbag assembly, keep the airbag deployment side facing upward.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01GIN8

      Remove the 4 bolts.

    4. Detach the clip from and the driver side knee airbag assembly.

    5. Detach the claw to disconnect the hood lock control lever sub-assembly from the driver side knee airbag assembly.

    6. Using a screwdriver release the airbag connector lock.

    7. Disconnect the airbag connector.

      Note

      When disconnecting airbag connector, take care not to damage the airbag wire harness.

  9. REMOVE NETWORK GATEWAY ECU


    1. A01GM4L

      Disconnect each connector.

    2. A01GLGK

      Remove the 2 nuts and No. 1 ECU integration bracket.

    3. A01GLSM

      Remove the 2 nuts and network gateway ECU.