AMPLIFIER ANTENNA REMOVAL


  1. PRECAUTION

    CAUTION:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    A01GM4S

    1. Remove the 6 clips and cowl top ventilator louver RH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR SEAT ASSEMBLY


    1. for Power Seat:

      Click here

    2. for 4-Passenger with Ottoman:

      Click here

    3. for 5-Passenger with Ottoman:

      Click here

    4. for Fixed seat:

      Click here

  5. REMOVE ROOF HEADLINING


    1. Partially remove the roof headlining.

      Tech Tips

      It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining so that the amplifier antenna can be removed.

      for Standard Body:

      Refer to the following procedures Click here.

      for Long Body:

      Refer to the following procedures Click here.

  6. REMOVE AMPLIFIER ANTENNA ASSEMBLY NO.1


    1. Disconnect each connector.

    2. Detach the 4 clamps labeled A and remove the 2 nuts labeled B.

    3. Detach the clip labeled C and remove the amplifier antenna.

      Tech Tips


      • Remove the clip if it is damaged.

      • The clip is used when the vehicle is assembled at the factory and is not needed for the reinstallation.

      A01GK0JE01