DIGITAL AUDIO BROADCASTING ANTENNA INSTALLATION


  1. INSTALL AMPLIFIER ANTENNA ASSEMBLY NO.2


    1. Use non-residue solvent to clean the area on the glass where the antenna will be installed.

      Note

      Do not use non-residue solvent to clean the antenna's contact points. Doing so may cause improper contact between the antenna and glass.

    2. Install the amplifier antenna assembly with the 2 nuts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note


      • Just before installing the antenna to the glass, remove the protective cover of the antenna's contact points.

      • When removing the protective cover of the antenna's contact points, make sure the cover does not touch the contact points.

      • Never touch the contact points after removing the protective cover.

      Tech Tips


      • A01GM9VE01

        Do not reuse the plate if damaged heavily.

      • The plate is used when the vehicle is assembled at the factory. Therefore the antenna performance is not affected by not reusing it.

        Text in Illustration
        *1 Plate
    3. Attach the 2 clamps.

    4. Connect the connector and install the amplifier antenna assembly.

  2. INSTALL ROOF HEADLINING ASSEMBLY


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.