INSTALL AMPLIFIER ANTENNA ASSEMBLY NO.2
Use non-residue solvent to clean the area on the glass where the antenna will be installed.
Note
Do not use non-residue solvent to clean the antenna's contact points. Doing so may cause improper contact between the antenna and glass.
Install the amplifier antenna assembly with the 2 nuts.
Note
Just before installing the antenna to the glass, remove the protective cover of the antenna's contact points.
When removing the protective cover of the antenna's contact points, make sure the cover does not touch the contact points.
Never touch the contact points after removing the protective cover.
Tech Tips
Do not reuse the plate if damaged heavily.
The plate is used when the vehicle is assembled at the factory. Therefore the antenna performance is not affected by not reusing it.
*1 | Plate |
Attach the 2 clamps.
Connect the connector and install the amplifier antenna assembly.
INSTALL ROOF HEADLINING ASSEMBLY
for Standard Body:
for Long Body:
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL COWL TOP VENTILATOR LOUVER RH
Install the 6 clips and cowl top ventilator louver RH.
Note
If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.