HEADLIGHT DIMMER SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Remove the 6 clips and cowl top ventilator louver RH.

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Click here

  5. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    A01GNNG

    1. Disconnect the connectors.

    2. Using a screwdriver, detach the claw to remove the windshield wiper switch assembly.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      If the claw is pressed forcefully, it will break.

  6. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

    A01GMIS

    1. While loosening the band clamp, detach the claw to remove the turn signal switch assembly.

      Note

      If the claw is pressed forcefully, it will break.