CRUISE CONTROL MAIN SWITCH REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      for LHD:

      Remove the 6 clips and cowl top ventilator louver RH.

    2. A01GI9P

      for RHD:

      Remove the 6 clips and cowl top ventilator louver LH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A01GNM7E03
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the lower No. 3 steering wheel cover.

    2. Using a screwdriver, detach the claw to remove the lower No. 3 steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A01GNGOE03
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the lower No. 2 steering wheel cover.

    2. Using a screwdriver, detach the claw to remove the lower No. 2 steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE STEERING PAD

    CAUTION:

    When storing the steering pad, keep the airbag deployment side facing upward.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01GLPZE01
      Text in Illustration
      *1 Torsion Spring

      Using a screwdriver, push the 3 torsion springs to detach the 3 pins as shown in the illustration.

      Tech Tips

      Insert the screwdriver into the installation holes in the lower No. 3 steering wheel cover and lower No. 2 steering wheel cover.

    4. A01GHXQ

      Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

      Note


      • When removing the steering pad, do not pull the airbag wire harness.

      • Do not drop the steering pad.

    5. Using a screwdriver release the 2 airbag connector locks.

    6. Using a screwdriver disconnect the 2 airbag connectors from the steering pad.

      Note

      When disconnecting airbag connector, take care not to damage the airbag wire harness.

    7. Disconnect the horn connector from the steering pad to remove the steering pad.

  7. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY


    1. A01GMI6

      Remove the 2 screws.

    2. A01GJ8M

      Disconnect the connector and remove the cruise control main switch assembly.