ELECTRIC PARKING BRAKE ACTUATOR REMOVAL


  1. RELEASE PARKING BRAKE


    1. With the engine switch on (IG), operate the electric parking brake switch to release the parking brake. Then turn the engine switch off.

      Tech Tips

      If the parking brake cannot be released, use the luggage compartment's parking brake release tool to manually release the parking brake (refer to the Owner's Manual).

  2. REMOVE COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Remove the 6 clips and cowl top ventilator louver RH.

    2. A01GI9P

      for RHD:

      Remove the 6 clips and cowl top ventilator louver LH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR WHEEL

  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  6. DISCONNECT WIRING HARNESS CONNECTOR


    1. A01GLTX

      Disconnect the trunk interior's electric parking brake actuator grommet and connector.

  7. REMOVE REAR WHEEL HOUSE LINER LH

    A01GHZUE01

    1. Remove the 3 screws, 11 nuts and 2 clips from the liner.

  8. DISCONNECT WIRE HARNESS CLAMP

    A01GI7G

    1. Remove the clamps shown in the illustration.

  9. REMOVE FLOOR NO. 1 UNDER COVER


    1. Remove the 2 hole plugs.

    2. A01GMO3

      Remove the 5 nuts, 5 clips and under cover.

  10. DISCONNECT PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  11. DISCONNECT ELECTRIC PARKING BRAKE ACTUATOR CAP


    1. A01GJ2N

      Remove the electric parking brake actuator emergency release cable cap and 2 nuts.

  12. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  13. DISCONNECT PARKING BRAKE CABLE

    Click here

  14. REMOVE PARKING BRAKE W/BRACKET ACTUATOR ASSEMBLY


    1. A01GM51

      Remove the bolt and 5 nuts.

    2. Detach the clamp from the member.

    3. A01GNR5

      Remove the 3 harness clamps from the member.

    4. A01GJKA

      Remove the 3 nuts and actuator.