FRONT BRAKE (for 6-Pot Caliper) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.


  1. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Remove the 6 clips and cowl top ventilator louver RH.

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT WHEEL

  5. DRAIN BRAKE FLUID

    Note

    Wash brake fluid off immediately if it is spilled on any painted surface.

  6. DISCONNECT FRONT FLEXIBLE HOSE


    1. A01GNG1

      Remove the union bolt and gasket and disconnect the front flexible hose from the front disc brake cylinder assembly.

  7. REMOVE FRONT DISC BRAKE PAD

    Note

    Be sure to inspect the front disc when replacing the brake pads with new ones Click here.


    1. A01GMAQE01
      Text in Illustration
      *1 Ring

      Using a pin punch (5 mm) and hammer, detach the ring of the pad guide pin (upper) and push out the pad guide pin (upper) from the front disc brake cylinder assembly.

      Note

      Do not damage the disc brake cylinder surface.

    2. A01GIJI

      While holding the anti-rattle spring, remove the pad guide pin (upper) from the front disc brake cylinder assembly.

    3. Remove the anti-rattle spring (upper) from the front disc brake cylinder assembly.

    4. A01GJK2E01
      Text in Illustration
      *1 Ring

      Using a pin punch (5 mm) and hammer, detach the ring of pad guide pin (lower) and remove the pad guide pin (lower) from the front disc brake cylinder assembly.

      Note

      Do not damage the disc brake cylinder surface.

    5. A01GMV2

      While holding the anti-rattle spring, remove the pad guide pin (lower) from the front disc brake cylinder assembly.

    6. Remove the anti-rattle spring (lower) from the front disc brake cylinder assembly.

    7. A01GLCM

      Remove the bolt and pad guide tie rod (upper) from the front disc brake cylinder assembly.

    8. A01GJX2

      Remove the bolt and pad guide tie rod (lower) from the front disc brake cylinder assembly.

    9. Remove the 2 front disc brake pads from the front disc brake cylinder assembly.

    10. A01GJOKE01
      Text in Illustration
      *1 Retainer
      *2 Pad Wear Indicator Wire

      Remove the retainer and pad wear indicator wire from the inner pad.

    11. A01GILDE02

      Disconnect the pad wear indicator wire connector (labeled A).

    12. Detach the clamp (labeled B) and bleeder plug cap (labeled C).

  8. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY


    1. A01GJKB

      Remove the 2 bolts and front disc brake cylinder assembly from the knuckle.

  9. REMOVE FRONT DISC


    1. A01GIFJE02
      Text in Illustration
      *a Matchmark

      Remove the front disc from the front axle hub.

      Tech Tips

      Put matchmarks on the disc and axle hub.