BRAKE PEDAL SUPPORT (for RHD) REMOVAL

Tech Tips

The following procedures are for RHD vehicles.
For LHD vehicles, refer to the procedures for LHD vehicles Click here.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PRECAUTION

CAUTION:

Be sure to read the Precaution thoroughly before servicing Click here.

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.
REMOVE COWL TOP VENTILATOR LOUVER
1. for LHD:
  
  Remove the 6 clips and cowl top ventilator louver RH.
2. for RHD:
  
  Remove the 6 clips and cowl top ventilator louver LH.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
DISCONNECT CONNECTORS
1. Disconnect the brake pedal stroke sensor connector (labeled A).
2. Disconnect the stop light switch connector (labeled B), and then detach the wire harness clamp (labeled C).
REMOVE BRAKE PEDAL RETURN SPRING
1. Remove the spring.
REMOVE PUSH ROD PIN
1. Text in Illustration
  
  *1 Push Rod Pin
  
  *2 Clip
  
  Remove the clip and push rod pin.
REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
1. Remove the 4 nuts.
2. Text in Illustration
  
  *1 Brake Pedal Support
  
  Remove the 2 bolts and brake pedal support.

Text in Illustration
*1	Push Rod Pin
*2	Clip