FRONT SPEED SENSOR (for 2WD) REMOVAL

Tech Tips


  • The front speed sensor is a component of the front axle hub sub-assembly. If the sensor malfunctions, replace the front axle hub sub-assembly.

  • The procedures listed below are for the RH side.

  • Use the same procedures for the LH side and RH side.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.


  1. REMOVE COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Remove the 6 clips and cowl top ventilator louver RH.

    2. A01GI9P

      for RHD:

      Remove the 6 clips and cowl top ventilator louver LH.

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT WHEEL

  5. REMOVE SKID CONTROL SENSOR WIRE


    1. A01GKX4E04
      Text in Illustration
      *1 Front Fender Liner

      Disconnect the front fender liner so that the skid control sensor wire connector can be seen.

    2. Disconnect the sensor connector.

    3. Detach the sensor clip.

    4. Remove the bolt and sensor clamp.

    5. A01GL8M

      Remove the 2 bolts and 2 sensor clamps.

    6. A01GJO5

      Disconnect the pad wear indicator connector.

    7. Remove the bolt and sensor clamp.

    8. Disconnect the connector from the front speed sensor.

      Note


      • Be careful not to damage the speed sensor.

      • Prevent foreign matter from adhering to the speed sensor.

  6. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY


    1. A01GHWY

      Remove the 2 bolts and disc brake caliper from the knuckle.

  7. REMOVE FRONT DISC


    1. A01GKBTE02
      Text in Illustration
      *a Matchmark

      Put matchmarks on the front disc and the axle hub if planning to reuse the disc.

    2. Remove the front disc.

  8. REMOVE FRONT AXLE HUB SUB-ASSEMBLY

    Tech Tips

    The front speed sensor is a component of the front axle hub sub-assembly. If the sensor malfunctions, replace the front axle hub sub-assembly.


    1. Remove the front axle hub Click here.