STEERING ANGLE SENSOR INSTALLATION

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.


  1. INSTALL STEERING SENSOR


    1. A01GJJHE05
      Text in Illustration
      *1 Pin

      Align the pins on the spiral cable with the installation holes on the steering sensor.

    2. Attach the 6 claws and install the spiral cable to the steering sensor.

  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable sub-assembly with the battery connected and the engine switch on (IG).

    • Do not rotate the spiral cable sub-assembly with the battery connected and the engine switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Check that the front wheels are facing straight ahead.

    4. Attach the 3 claws to install the spiral cable sub-assembly with sensor.

      Note

      When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly.

    5. A01GM5B

      Connect the yellow airbag connector to the spiral cable sub-assembly with sensor.

    6. Connect the connectors to the spiral cable sub-assembly with sensor.

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

  3. INSTALL STEERING COLUMN COVER


    1. w/o VGRS:

      Click here

    2. for 2WD with VGRS:

      Click here

    3. for AWD with VGRS:

      Click here

  4. ADJUST SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

    Note

    Do not adjust the spiral cable sub-assembly with sensor with the battery connected and the engine switch on (IG).


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01GNO3

      Rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.

      CAUTION:

      Do not turn the spiral cable sub-assembly using the airbag wire harness.

    4. A01GLREE01
      Text in Illustration
      *A w/o Steering Heater
      *B w/ Steering Heater
      *a Alignment Mark

      Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable sub-assembly using the airbag wire harness.

      Tech Tips

      The spiral cable sub-assembly will rotate approximately 2.5 turns to both the left and right from the center.

  5. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.

  8. INSPECT STEERING PAD

    Click here

  9. CHECK SRS WARNING LIGHT

    Click here