TIRE PRESSURE WARNING RECEIVER REMOVAL

Tech Tips


  • Use the same procedure for the RHD and LHD models.

  • The procedure listed below is for the LHD model.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE TELEMATICS TRANSCEIVER

    Click here

  4. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER


    1. A01GIWG

      Disconnect the connector.

    2. Remove the bolt and tire pressure warning ECU and receiver.